Replacement knobs for your Westfalia kitchen, available as standard replacements or with a locking beam. The locking beam makes it harder to accidentally turn on the gas, or for small humans to turn it on by mistake. The beam must be lifted with one hand while you push and turn the knob with your other […]
Simple replacement seals for the cabin door handles. Includes a raised section to replace the little foam block fitted from the factory. Printed in a flexible rubber like material for a good seal. Item is for a single door, comes with the seal for the front and rear of the handle. If this isn’t quite […]
Replacement seal that lives between the 3 screw wing mirrors and the door skin. Can be cut on the thin sections to install without removing the wiring harness. Sold individually. If this isn’t quite what you’re looking for, or you want something similar for another vehicle, please just get in contact. We’re always looking to […]
The little plug that covers the threads and nuts on the wiper arm. If this isn’t quite what you’re looking for, or you want something similar for another vehicle, please just get in contact. We’re always looking to expand our product range. Please look closely at the photos to ensure this item will […]
Do you ever fill your water tank up on the road, without a hose? Do you get frustrated that it always seems to spill as you pour wasting that precious resource? Now there’s a solution, this very specific shape funnel designed to fit snugly into the Westfalia water fill hole and provide a large and […]
Replacement for the VW part, which is reported to be no longer available. Now it is longer available. If yours is broken or missing it might be where the mice are getting in… Split design, so you don’t have to remove the throttle cable if ever removing this cover. Just slot the two halves together […]
Replaces the original pedal, fits into the same holes and the original throttle linkage that goes through the floor clicks right in. Slightly wider than the original, has a similar aesthetic. Also has a slot on the side which allows the use of the Subaru throttle-by-wire sensors. Check the photos to see where the sensor […]
A cover designed to fit the hole left behind when removing the Westfalia propane fridge exhaust. Using multi-material 3D printing, there is a hollow rubber gasket printed onto the back face and sealing rings in each counter sunk screw hole. As such, if a colour that isn’t black is chosen there will be visible black […]
Bolt in replacement for the backing plate behind the cabin dome lights. Perfect if you want to additional lights in the cabin such as above the passenger door or in the centre. The original is held in place with rivets but this uses short internal hex screws (provided). These are a very similar aesthetic and […]
If your seat doesn’t swivel like it once did, why not replace the bushings? These fit the later seat swivel bases, earlier ones did not have bushings. As a part that is invisible once installed, the colour may vary. Contains 4 upper and 4 lower, enough to do one whole seat base. If this isn’t […]
