Absolutely terrible, quick and dirty, half solution for those shrinking rubber trim pieces scattered around the Westfalia interiors. This is only for the thicker rubber profile, but these are the ones that shrink the most.
These come in 80mm lengths, 2 should be plenty but 1 may be enough depending on your shrinkage. It is worth measuring the gaps in your van and adding them all up. Very easy to cut cleanly to the correct lengths when it comes to fitting.
Please note the colours do not quite match the original interior. See photos.
If this isn’t quite what you’re looking for, or you want something similar for another vehicle, please just get in contact. We’re always looking to expand our product range.
Please look closely at the photos to ensure this item will fit on your vehicle. If in doubt, please get in touch.
There is a chance that the colour you receive may not match exactly with what you see on your screen. For the latest colours, please see the colour chart photo.
Due to the nature of 3D printing, each part will come out slightly different from the last. But the differences will be subtle. The design may also have been improved slightly since the product photo was taken.
If there’s anything complex about fitting or using the product then an instructions sheet will be included to make sure everything goes smoothly.